Axxess-interface OESWC-7552-RF Instrukcja Użytkownika Strona 3
- Strona / 8
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Wiring The OESWC Interface
1. Connect the red wire to 12 volt accessory
2. Connect the Black wire to ground (you may use the same ground that
you use for the aftermarket radio)
Setting Up The OESWC Transmitter
1. Press the Red and Green buttons simultaneously for 5 seconds, and
then press volume up for two seconds. This will orientate your button
direction.
2. Turn on the ignition and press volume up on the OESWC transmitter.
This will “marry“ the transmitter to the interface.
NOTE: If you are replacing a transmitter you must turn on the ignition
and within the rst 10 seconds press and hold the source button for ten
seconds. This will “marry the new transmitter.
Programming The OESWC Transmitter
1. Complete connections to the factory radio
* If this is the rst time the OESWC TRANSMITTER is being installed in a
vehicle:
2. Turn the ignition on; the led will start ashing rapidly which means the
OESWC interface is looking for the vehicle. Go to step 4.
Or
* If the OESWC TRANSMITTER was installed in a vehicle before:
2. Turn the ignition on, the led will ash once.
3. Hold down the reset button for more then 2 seconds but less then 10
seconds, the led will start ashing rapidly
4. After a couple of seconds the led should stop ashing and not light up
2
Powiązane produkty i podręczniki dla Satelita Axxess-interface OESWC-7552-RF
(8 strony)Johnson-level-tool-mfg RAS-1 Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Werkzeug Johnson-level-tool-mfg RAS-1.
Wir stellen 1 PDF-Handbücher Johnson-level-tool-mfg RAS-1 zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Komentarze do niniejszej Instrukcji